Limit Switch


Overview

A limit switch sits near the end of a slide's travel, and is pressed by the slide (or a stop fixed to it) when the slide gets there. On a machine moved by motors, it tells the controller to stop before the slide runs into the end of its travel, the chuck, or the work.

This matters because a stepper motor does not know where the slide is. If it is told to go too far, it keeps pushing: it may bend or break something, and once it slips, the controller no longer knows where the slide is.

The usual kind for ornamental turning is a small mechanical microswitch, often with a roller on its lever. Magnetic (reed), inductive proximity and optical switches are also used.


 

Normally Closed or Normally Open

A switch's contacts are either:

  • Normally closed (NC) - closed until the switch is pressed; pressing it opens the circuit.
  • Normally open (NO) - open until the switch is pressed; pressing it closes the circuit.

Normally closed is the safer choice. With NC, a broken wire, a loose plug or a switch that has been unplugged looks just like a pressed switch, so the machine stops and the fault is found at once. With NO, a broken wire looks like a switch that has not been pressed: the machine runs on as if all is well, and the switch silently does nothing - until the slide runs into the end.

  • Test each limit switch after fitting it, and after any change to its wiring. Press it by hand, or move the slide slowly onto it, and check the controller stops.

 

More Than One Switch on an Axis

A slide usually needs a switch at each end. There are two ways to connect them:

  • Both on one input. NC switches are wired in series (any one opening the circuit trips it); NO switches in parallel (any one closing it trips it). This uses only one input, but the controller cannot tell which end was reached, so it cannot tell which way is safe to move. Usually there is a way to override the limits so the slide can be moved off the switch by hand - in the right direction.
  • One input for each end (a minimum and a maximum switch). The controller knows which end was reached, so it can let the slide move away from that end only.

 

Placing Them

  • Place each switch so it trips with some travel to spare: the slide needs a little distance to stop, more at higher speeds.
  • Mount it so the slide cannot carry on past and break the switch - most switches allow only a little travel after they trip.
  • Keep limit switch wires away from stepper motor wires, or use shielded cable. Long switch wires running beside motor wires can pick up electrical noise and trip the switch when nothing has touched it.

A home switch looks the same, but is used to find a known starting position, not to stop the slide. One switch can do both jobs on some controllers.

######################################################################## ### Additional pictures of this device ########################################################################

Additional pictures of this device

######################################################################## ### Examples of this device in use ########################################################################

Examples of this device in use

######################################################################## ### More Information ########################################################################

More Information

Published Articles

Books and Papers

Web Sites

  • More information is available on Wikipedia at Limit Switch.

Presentations

Other

########## Standard Footer for all pages ##########

About this Site

Disclaimer: eMail comments to me at OTBookOfKnowledge @ Gmail.com. The process of woodturning involves the use of tools, machinery and materials which could cause injury or be a health hazard unless proper precautions are taken, including the wearing of appropriate protective equipment.